NEC POWERMATE ES 5250 - Replacing the System Board - Minitower

Installing Options 5-49
Removing the system board — minitower
A
– Chassis Floor
D
– Riser Board
B
– System Board
E
– System Board Connector
C
– Handles
Replacing the System Board — Minitower
Use the following procedure to replace the system board.
1.
Align the system board rails with the chassis rail guides
(see the following figure).
2.
Use the two handles on the board to carefully slide the
system board partway into the chassis, along the rail
guides.
3.
Stop sliding the board when the outside edge of the
system board aligns with the hinged edge of the chassis
floor.