5-76 Installing Options
Network Board Wake-On LAN Cabling
If your computer has the optional 10/100 MB network board,
your system can be readied for “Wake-On LAN” by
connecting the Wake-On LAN cable. Wake-On LAN allows
your system to be powered up remotely by a server computer.
Cable the network board for Wake-On LAN as follows.
1. Remove the cover.
In a small desktop or desktop system, see “Removing
the Small Desktop or Desktop Cover.”
In a minitower system, see “Removing the Minitower
Side Covers.”
2. Locate the Wake-ON LAN connector on the riser board.
See one of the following figures:
“Riser board auxiliary cable connectors — small
desktop”
“Riser board auxiliary cable connectors — desktop”
“Riser board auxiliary cable connectors —
minitower.”
3. If necessary, remove any expansion boards that may be in
the way (see “Installing and Removing Expansion
Boards”).
4. Connect one end of the Wake-ON LAN cable to its
connector on the riser board.
5. Connect the other end of the Wake-ON LAN cable to the
network board (see the documentation that comes with
the option).
6. Replace any expansion board (see “Installing and
Removing Expansion Boards”).
To Next Page
Loading...
