Installing Options 5-25
3. Press the plastic clips at the outer edges of the socket
away from the memory module (see the following figure).
This ejects the DIMM from the socket.
Removing a DIMM
A
– Plastic Clip
4. If installing a DIMM, see the next section, “Installing a
DIMM.”
5. If you are not installing a DIMM, slide the system board
into the chassis.
In a small desktop system, see “Replacing the System
Board — Small Desktop.”
In a desktop system, see “Replacing the System Board
— Desktop.”
In a minitower system, see “Replacing the System
Board — Minitower.”
6. Replace the cover(s):
For a small desktop or desktop system, see
“Replacing the Small Desktop or Desktop Cover.”
For a minitower system, see “Replacing the
Minitower Side Covers.”
To Next Page
Loading...
