Installing Options 5-43
A
– Latch in Incorrect Position
C
– Edge of Chassis
B
– System Board Rail
D
– Edge of System Board
!
CAUTION
To prevent damage to the latch, align the system
board with the outside edge of the chassis before
closing the latch.
4.
Push the latch closed. This slides the board the rest of the
way into the system unit and secures it into the connector
on the riser board.
!
CAUTION
If the board does not slide when you push the
latch, slide the board out of the unit a bit and
check the alignment position (see the previous
figures). Push the latch closed.
To Next Page
Loading...
