NEC POWERMATE ES 5250 - Page 185

Installing Options 5-69
Use the following table when configuring IDE drives on the
primary and secondary IDE connectors on the riser board.
If installing a DVD-ROM device, substitute the DVD-ROM
for the CD-ROM in the following table.
IDE Connector Configuration
Configuration Primary connector Secondary connector
1 device (hard drive) Master - hard drive
Slave - none
Master - none
Slave - none
2 devices (hard drive,
CD-ROM)
Master - hard drive
Slave - none
Master - CD-ROM
Slave - none
2 devices (hard drive, tape
backup)
Master - hard drive
Slave - none
Master - tape backup
Slave - none
2 devices (hard drive,
Zip drive)
Master - hard drive
Slave - none
Master - Zip drive
Slave - none
2 devices (hard drive,
LS-120 drive)
Master - hard drive
Slave - none
Master - LS-120 drive
Slave - none
3 devices (hard drive,
CD-ROM, Zip drive)
Master - hard drive
Slave - none
Master - CD-ROM
Slave - Zip drive
3 devices (hard drive,
CD-ROM, tape backup)
Master - hard drive
Slave - none
Master - CD-ROM
Slave - tape backup
3 devices (hard drive,
CD-ROM, LS-120 drive)
Master - hard drive
Slave - none
Master - CD-ROM
Slave - LS-120 drive
3 devices (hard drive, hard
drive, CD-ROM)
Master - hard drive
Slave - hard drive
Master - CD-ROM
Slave - none
3 devices (hard drive, hard
drive, tape backup)
Master - hard drive
Slave - hard drive
Master - tape backup
Slave - none
3 devices (hard drive, hard
drive, Zip drive)
Master - hard drive
Slave - hard drive
Master - Zip drive
Slave - none
3 devices (hard drive,
hard drive, LS-120 drive)
Master - hard drive
Slave - hard drive
Master - LS-120 drive
Slave - none