5-94 Installing Options
Internal hard drive screws — desktop
4. With the cable connectors toward the interior of the
system, place the new the hard drive in the bracket and
align the screw holes.
5. Insert and tighten the two screws to secure the hard drive
in the bracket.
6. Connect the device cables (see “Connecting Device
Cables” and “Cabling Storage Devices”).
7. Replace the system unit cover (see “Replacing the Small
Desktop or Desktop Cover”).
8. Run the Setup program to set the new configuration (see
“CMOS Setup Utility” in Chapter 3).
To Next Page
Loading...
