5-98 Installing Options
Locating an internal hard drive — minitower
A
– Hard Drive
C
– Drive Bracket
B
– Latch
D
– Screws (2 to a side)
5.
If a currently installed hard drive is being replaced,
remove the drive:
Label and disconnect the IDE drive signal and power
cables from the hard drive.
Remove the four screws (two to a side) securing the
drive to the drive bracket.
Remove the drive from the drive bracket.
6.
Insert the new hard drive in the bracket, with the
connectors on the drive facing the interior of the chassis.
7.
Secure the hard drive in the drive bracket with the four
screws from the old device or the screws that come with
the new device.
8.
Connect the IDE drive signal and power cables to the
hard drive.
9.
Align the drive bracket with its bay in the chassis and
slide the bracket into the chassis until it clicks in place.
To Next Page
Loading...
