3. Reinstall the CompactFlash card and power up the system.
SECTION 2 START-UP (DEFAULT) INMAIL CONFIGURATION
When you install the InMail Board and turn on the system, InMail has the following default
programming:
• Subscriber Mailboxes are enabled for extensions 101 ~ 164. The mailbox numbers are the same as
the extension numbers.
• The Automated Attendant does not answer outside calls.
• The InMail does not answer internal calls.
SECTION 3 BASIC FUNCTIONS WITHOUT MAIN GREETING
To make the InMail answer, the following programming must be done. The example shown is for a 4-
port InMail. Extension, Group and Pilot Numbers shown can be adjusted as needed per installation
requirements.
Refer to the SL1100 Programming Manual (Separate Issue) for more detailed programming
instructions.
Example
Program Number Description
47-01-17 Set first port of In-Mail to 25.
10-09-01 Verify at least one resource is set to ICM/TRK or Common.
11-07-01 Set TEL Group Pilot 2 to 200.
Never use Group 1, as this is the default group for all extensions.
15-03-01 Set extension 125 ~ 128 to DP.
15-03-03 Set extension 125 ~ 128 to Special.
16-02-01 Put 125 ~ 128 in Group 2.
Assign priorities 1 ~ 4 to 125 ~ 128.
16-01-01 Set Group 2 name to VM Hunt.
16-01-10 Set Group 2 to Busy/No Answer.
45-01-01 Set to Group 2.
With Ver3.0 or higher software, InMail Auto Setting feature is available. (V3.0 or higher)
This feature will automatically program the required InMail settings when an InMail CF is installed into
a SL1100 system. (V3.0 or higher)
Refer to InMail-Auto Setting on page 2-126. (V3.0 or higher)
SECTION 4 ENABLE THE MAILBOXES FOR ALL INSTALLED
EXTENSIONS
Since by default only extensions 101 ~ 164 have Subscriber Mailboxes, you should enable additional
Subscriber Mailboxes for all installed extensions.
To enable additional Subscriber Mailboxes:
SL1100
ISSUE 3.5
1-2
Quick Setup
To Next Page
Loading...
