NEC SL1100 - Auto Time Stamp

Auto Time Stamp
Description
After a Subscriber Mailbox user listens to a message, InMail can optionally announce the time and
date the message was left. The Subscriber can enable Auto Time Stamp from their mailbox, or it can
be enabled in system programming. Auto Time Stamp helps if the subscriber needs to know the time
and date of each message they receive without taking any extra steps. With Auto Time Stamp turned
on, InMail automatically announces the date, time, and (optionally) the caller's number at the end of
each message. With Auto Time Stamp turned off, the subscriber must dial TI (84) while listening to a
message to get the same information.
Related Features
Mailbox Options Menu on page 2-165
Auto Time Stamp is available on the Mailbox Options Menu.
Time and Date on page 2-234
InMail uses the InMail Time and Date.
Time and Date Stamp on page 2-235
An extension can listen to a message and dial a code to hear the time the message was sent.
Programming
1. Enable Auto Time Stamp from your Subscriber Mailbox.
Refer to Operation on page 2-29.
2. Optionally Enable Auto Time Stamp from System Programming.
Program
Number
Program Name Description
47-02-11 Auto Time Stamp Enter 1 (Yes) to enable Auto Time Stamp.
By default, Auto Time Stamp is disabled (0).
Operation
Turning Auto Time Stamp On or Off
Log On to Subscriber Mailbox.
OP (67) Access the Mailbox Options Menu.
[Not applicable]
AT (28) Access Auto Time Stamp.
[Time]
ISSUE 3.5 SL1100
InMail Feature Manual 2-29
A