NEC SL1100 - Page 146

Program
No.
Program Name / Description Input Data Default
15-03-01 Single Line Telephone Basic Data Setup - SLT
Signaling Type
Assign all extension numbers to be used for Voice
Mail to a signaling type of DP.
0 = DP
1 = DTMF
1
15-03-03 Single Line Telephone Basic Data Setup - Termi-
nal Type
Enter 1 for this option to allow a single line port to
receive DTMF tones after the initial call setup. Enter
0 to have the port ignore DTMF tones after the initial
call setup. For Voice Mail, always enter 1 (e.g., re-
ceive DTMF tones).
0 = Normal
1 = Special
0
16-02-01 Department Group Assignment
InMail ports
113-128 (V3.5 Changed)
are automatically assigned to Department Group 32.
1 ~ 32
If department group 32 al-
ready used, InMail auto set-
ting does not function. (V3.0
Added)
No Setting
Operation
Cold Start
1. Turn SL1100 power off.
2. Install InMail CF on PZ-VM21.
3. Once the system has powered down, push in and hold the Load button.
4. Turn SL1100 power on.
5. Continue holding the Load button for approximately three seconds or until Status LED (D5) starts
flashing red.
6. Release the Load button.
7. Programming changes are made automatically.
Warm Start
1. Turn SL1100 power off.
2. Install InMail CF on PZ-VM21.
3. Turn SL1100 power on.
4. Programming changes are made automatically.
SL1100 ISSUE 3.5
2-128
InMail-Auto Setting
I