Chapter 7 Disk Array Configuration Setting
IV-41
(6)-1 Specifying the number of logical disks
Check-marking on [Only specify the number of LDs] on the “Binding Method” screen and clicking the [Next]
button displays the “Specify Number of LDs” screen.
Figure 7-35 Specifying the Number of Logical Disks
Number of LDs: Specify the number of logical disks to bind.
Each logical disk is bound in the unit of 1 GB, and the maximum available capacity is
automatically calculated.
[Next] button: Displays the “Setting Detail Parameter for LD Binding” screen.
[Back] button: Displays back the “Binding Method” screen.
[Cancel] button: Displays a confirmation to ask whether you want to quit the wizard, then the wizard closes if
agreed.
To Next Page
Loading...
