Chapter 7 Disk Array Configuration Setting
IV-72
(5)-3 Specifying the number of logical disks and the logical disk capacity
Check-marking on [Specify both the number of LDs and LD capacity] on the “Binding Method” screen and
clicking the [Next] button displays the “Specify Number of LDs and LD Capacity” screen.
Figure 7-63 Specifying the Number of Logical Disks and Logical Disk Capacity
Specify the number of logical disks according to (5)-1.
Specify the capacity of the logical disks according to (5)-2.
[Next] button: Displays the “Setting Detail Parameter for LD Binding” screen.
[Back] button: Displays back the “Binding Method” screen.
[Cancel] button: Displays a confirmation to ask whether you want to quit the wizard, then the wizard closes
if agreed.
Selecting a logical disk and clicking the [Reference] button displays the following screen:
To Next Page
Loading...
