Chapter 8 Disk Array Configuration Setting (S100/S1100/S1200/S1300/S2100/S2200/S2300)
IV-113
(c) Rebuild Time
Specifies the maximum time required for rebuilding the RANK. It is possible to select 0 to 24 hours as
Rebuild Time. Select 0 to perform rebuilding in the shortest amount of time. In consideration of the host
I/O load, set a suitable value for Rebuild Time. Moreover, the time is an indication and it does not always
take the time as specified.
Change the RANK Rebuild Time by using the “Change Rebuild Time” previously described.
If LDs are not bound on the RANK, the rebuild start instruction fails.
To Next Page
Loading...
