Check description Node/cluster Action needed to
resolve
Knowledgebase article
with procedure
Is DRS enabled and fully
automated?
Cluster Turn on DRS and make
sure it is fully automated.
See this KB. NOTE:ÊIf you
have standard licensing,
put the ESXi host into
maintenance mode and
ignore this health check
failure warning.
Is DPM disabled in
vSphere?
Cluster Turn off Distributed Power
Management.
See this KB.
Is HA admission control
disabled in vSphere?
Cluster Turn off HA admission
control.
See this KB.
Is FT enabled for a VM on
a host in the cluster?
Node Suspend Fault Tolerance
on any affected virtual
machines.
See this KB.
Are there critical alarms in
vCenter for the cluster?
Cluster Launch vSphere and
resolve and/or
acknowledge any alerts
before proceeding.
No KB needed to resolve
issue.
Are there generic/global
informational alerts in
vCenter?
Cluster Launch vSphere and
resolve and/or
acknowledge any alerts
before proceeding.
No KB needed to resolve
issue.
Are management services
up to date?
HCI system You must update
management services
before you perform an
upgrade or run pre-
upgrade health checks.
No KB needed to resolve
issue. See this article for
more information.
Are there errors on the
current ESXi node in
vSphere?
Node Launch vSphere and
resolve and/or
acknowledge any alerts
before proceeding.
No KB needed to resolve
issue.
Is virtual media mounted
to a VM on a host in the
cluster?
Node Unmount all virtual media
disks (CD/DVD/floppy)
from the VMs.
No KB needed to resolve
issue.
Is BMC version the
minimum required version
that has RedFish support?
Node Manually update your
BMC firmware.
No KB needed to resolve
issue.
Is ESXi host up and
running?
Node Start your ESXi host. No KB needed to resolve
issue.
Do any virtual machines
reside on local ESXi
storage?
Node/VM Remove or migrate local
storage attached to virtual
machines.
No KB needed to resolve
issue.
To Next Page
Loading...
Need help?
General
