ReadySHARE Printer
67
N300 Wireless ADSL2+ Modem Router DGN2200v3
Control Center Configuration
Select Tools >Configuration to display the following screen:
Automatically execute when logging on Windows. Enable this utility to start automatically
when you are logged in to Windows.
Timeout. Specify the timeout value for holding the USB resource when it is not in use.
Language. Select the display language for this utility
.
USB Printer
The first time you use a printer, click Connect. You might be asked to install the driver for this
printer. After the driver is installed, the printer status changes to Available.
Note: Some USB printers (for example: HP and Lexmark printer) request
that you do not connect the USB cable until you the installation
software in their installation.
If the USB printer is detected and connected automatically, you need to disconnect the
printer
, and then wait for the prompt asking you to click Connect.
To Next Page
Loading...
Need help?
General
