VPN Configuration
153
N300 Wireless ADSL2+ Modem Router DGN2200v3
b. Type ping 172.23.9.1
If the pings fail the first time, try the pings a second time.
Configuration Summary (Telecommuter Example)
The configuration in this section follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather the necessary information before you begin configuration.
Verify that the firmware is up to date, and make sure you have all the addresses and
parameters to be set on both sides. Assure that there are no firewall restrictions
VPN Consortium Scenario Scenario 1
Type of VPN: PC/client-to-gateway, with client behind NAT router
Security scheme: IKE with pre-shared secret/key (not certificate based)
IP addressing:
Gateway Fully qualified domain name (FQDN)
Client Dynamic
.
Gateway A
(main office)
Gateway B
LAN IP
192.168.0.1
192.168.0.1/24
FQDN
ntgr.dyndns.org
“from_GW_A”
WAN IP
Internet
WAN IP
0.0.0.0
“toGW_A”
IP: 192.168.2.3
(regional office)
Client PC
(running NETGEAR
ProSafe VPN client)
Figure 17. Telecommuter Example
To Next Page
Loading...
Need help?
General
