NETGEAR FVS318 - ProSafe VPN Firewall Router User Manual

VPN Configuration of NETGEAR FVS318v3 E-1
January 2005
Appendix E
VPN Configuration of NETGEAR FVS318v3
This is a case study on how to configure a secure IPSec VPN tunnel on a NETGEAR FVS318v3.
This case study follows the VPN Consortium interoperability profile guidelines (found at
http://www.vpnc.org/InteropProfiles/Interop-01.html).
This study covers the following situations:
• FVS318v3 to FVS318v3 (see page E-6)
• FVS318v3 to FVS318v2 (see page E-13)
• FVS318v3 to FVL328 (see page E-20)
• FVS318v3 to VPN Client (see page E-27)
Case Study Overview
The procedure for configuring a VPN tunnel between two gateway endpoints is as follows:
1. Gather the network information
2. Configure gateway A
3. Configure gateway B
4. Activate the VPN tunnel
Gathering the Network Information
The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
Note: Product updates are available on the NETGEAR, Inc. Web site at
http://www.netgear.com/support/main.asp.

NETGEAR FVS318 - ProSafe VPN Firewall Router Specifications

General

Model	FVS318
Category	Firewall
WAN Ports	1
LAN Ports	8
VPN Pass-through	Yes
VPN Tunnels	8
SPI Firewall	Yes
Data Link Protocol	Ethernet, Fast Ethernet
VPN Protocol	IPSec
Compliant Standards	IEEE 802.3, IEEE 802.3u
RAM	8 MB
Flash Memory	4 MB
Power Supply	External power adapter
Network / Transport Protocol	TCP/IP, UDP
Encryption Algorithm	3DES
Features	NAT support, URL filtering, DHCP server, DoS attack prevention
Status Indicators	Port status, power