Reference Manual for the ProSafe VPN Firewall FVS318v3
Connecting the Firewall to the Internet 3-11
January 2005
If you do not click Logout, the VPN firewall router waits five minutes after there is no activity
before it automatically logs you out.
Using the Smart Setup Wizard
You can use the Smart Setup Wizard to assist with manual configuration or to verify the Internet
connection. The Smart Setup Wizard is not the same as the Smart Wizard Configuration Assistant
(as illustrated in Figure 3-5) that only appears when the firewall is in its factory default state. After
you configure the VPN firewall router, the Smart Wizard Configuration Assistant will not appear
again.
To use the Smart Setup Wizard to assist with manual configuration or to verify the Internet
connection settings, follow this procedure.
1. Connect to the VPN firewall router by typing http://www.routerlogin.net in the address field
of your browser, then press Enter.
2. For security reasons, the firewall has its own user name and password. When prompted, enter
admin for the firewall user name and password for the firewall password, both in lower case
letters. To change the password, see “Changing the Administrator Password” on page 7-8
Note: The firewall user name and password are not the same as any user name or password
you may use to log in to your Internet connection.
Once you have entered your user name and password, your Web browser should find the
FVS318v3 VPN Firewall and display the home page as shown in Figure 3-9.
3. Click Setup Wizard on the upper left of the main menu.
4. Click Next to proceed. Input your ISP settings, as needed.
5. At the end of the Setup Wizard, click the Test button to verify your Internet connection. If you
have trouble connecting to the Internet, use the Troubleshooting Tips “Troubleshooting Tips”
on page 3-6 to correct basic problems, or refer to Chapter 9, “Troubleshooting.”
To Next Page
Loading...
Need help?
General
