Reference Manual for the ProSafe VPN Firewall FVS318v3
5-4 Basic Virtual Private Networking
January 2005
FQDNs supplied by Dynamic DNS providers can allow a VPN endpoint with a dynamic IP
address to initiate or respond to a tunnel request. Otherwise, the side using a dynamic IP
address must always be the initiator.
• What method will you use to configure your VPN tunnels?
— The VPN Wizard using VPNC defaults (see Table 5-1)
— Advanced methods (see Chapter 6, “Advanced Virtual Private Networking”)
• What level of IPSec VPN encryption will you use?
— DE — The Data Encryption Standard (DES) processes input data that is 64 bits wide,
encrypting these values using a 56 bit key. Faster but less secure than 3DES.
— 3DES — (Triple DES) achieves a higher level of security by encrypting the data three
times using DES with three different, unrelated keys.
—AES
• What level of authentication will you use?
— MDS — 128 bits, faster but less secure.
— SHA-1 — 160 bits, slower but more secure.
Table 5-1. Parameters recommended by the VPNC and used in the VPN Wizard
Parameter Factory Default
Secure Association Main Mode
Authentication Method Pre-shared Key
Encryption Method 3DES
Authentication Protocol SHA-1
Diffie-Hellman (DH) Group Group 2 (1024 bit)
Key Life 8 hours
IKE Life Time 24 hours
NETBIOS Enabled
Note: NETGEAR publishes additional interoperability scenarios with various gateway
and client software products.
To Next Page
Loading...
Need help?
General
