Index | 107
NETGEAR N300 Wireless Router JWNR2000v2 User Manual
M
MAC addresses
described 30
QoS for 77, 80
restricting access by 73
spoofing 91
maintenance settings 55
managing router remotely 63
manual logout 28
Maximum Transmit Unit (MTU) 66
menus, described 21
metric value 76
mixed mode encryption 36
mixed mode security options 31
mode, communication 35
multicasting 70
N
NAT (Network Address Translation) 67
Neighbor Friendly mode 35
Network Address Translation (NAT) 26
Network Time Protocol (NTP) 44, 94
no Internet connection 27
O
On/Off LED 8
online games, QoS for 78
online help, router 21
Open System authentication 38
P
passphrases 37, 38
password
restoring 96
path, testing 94
Performance mode 36
PIN 73
ping 93
pinging WAN port 66
poll interval 62
port forwarding
configuring 49
port scanning, disabling 66
port status 61
port triggering
configuring 49, 51
portmap table 83
ports
filtering 42
listed, back panel 9
positioning the router 11
Power light, troubleshooting and 88
PPPoE 25
PPTP 25
PPTP (Point to Point Tunneling Protocol) 25
Preamble mode 72
primary DNS addresses 26
prioritizing traffic 76
Push ’N’ Connect 90
Q
QoS (Quality of Service) 76
R
radio, wireless 72
range of wireless connections 11
region of operation 35
remote devices, testing path 94
remote management 63
repeater units 85
replace existing router 18
reserved IP address 71
reserved IP adresses 70
restarting network 88
restore
configuration file 59
restoring
default factory settings 59, 96
restoring firmware 89
restricting access by MAC address 73
route name 76
router interface, described 21
router PIN 73
router, status 60
Routing Information Protocol (RIP} 69
S
secondary DNS 26
security 30
see also security options
security features 30
security options
described 31
settings 31
security PIN 33, 73
To Next Page
Loading...
Need help?
General
