98 | Appendix A. Supplemental Information
NETGEAR N300 Wireless Router JWNR2000v2 User Manual
Factory Default Settings
Table 1. Router Default Settings
Feature Default Setting
Router Login URL http://www.routerlogin.net or http://www.routerlogin.com
Login name (case-sensitive) admin (printed on product label)
Login password (case-sensitive) password (printed on product label)
WAN MAC address Default hardware address (on label)
MTU Size 1500
LAN IP address (gateway IP address) 192.168.1.1 (printed on product label)
Router subnet 255.255.255.0
DHCP server Enabled
DHCP range 192.168.1.2 to 192.168.1.254
Time zone GMT
Adjust for daylight saving time Disabled
Allow a registrar to configure this router Enabled
Wireless communication Enabled
SSID Name NETGEAR
Security Disabled
Wireless access list (MAC Filtering) All wireless stations allowed
Broadcast SSID Enabled
Transmission speed Auto
*
*. Maximum wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will vary.
Network conditions and environmental factors, including volume of network traffic, building materials and
construction, and network overhead lower actual data throughput rate.
Country/Region United States in NA only, otherwise varies by country and region
RF channel 6 until region selected
Operating mode 145 Mbps
Data rate Best
Output power Full
Inbound communication from the Internet Disabled (bars unsolicited requests except traffic on port 80, the
http port)
Outbound communication to the Internet Enabled (all)
To Next Page
Loading...
Need help?
General
