Chapter 3. Wireless Settings | 39
NETGEAR N300 Wireless Router JWNR2000v2 User Manual
1. Select Guest Network from the Setup menu. The Guest Network Settings screen
appears
.
2. Select any of the following Wireless settings:
• Enable Guest Network – When this check box is selected, the guest network is enabled,
and guests can connect to your network using the SSID of this profile.
• Enable SSID Broadcast – If selected, the Wireless Access Point broadcasts its name
(SSID) to all Wireless Stations. Stations with no SSID can adopt the correct SSID for
connections to this Access Point.
• Allow Guest to access MY Local Network – If selected any user who connects to this
SSID can access local networks associated with the router like users in the primary SSID.
3. Give the wireless network a name.
4. The name is case-sensitive and can be up to 32 characters. The same name must be
assigned to all wireless devices in your network. NETGEAR recommends that you
change the name to a different value.
5. Select a Security option from the list.
6. Click Apply to save your selections.
Figure 3-1
To Next Page
Loading...
Need help?
General
