Wireless Settings
37
N150 Wireless ADSL2+ Modem Router DGN1000
• While the wireless modem router attempts to connect to a WPS-capable device, the
WPS LED on the front of the wireless modem router blinks green. When the wireless
modem router establishes a WPS connection, the LED is solid green.
• If a connection is established, the wireless modem router WPS screen displays a
confirmation message.
4. Repeat to add another WPS client to your network.
Wireless Settings Screen
The Wireless Settings screen lets you view or configure the wireless network configuration. If
you want to make changes, note the current settings first. Once you have established basic
wireless connectivity, you can enable security settings appropriate to your needs. NETGEAR
recommends that you not change the Wi-Fi network name (SSID), WPA/WPA2-PAK
passphrase, or security option, but if you want to change these settings, this section
explains how.
Note: If you use a wireless computer to change the wireless network
name (SSID) or other wireless security settings, you are
disconnected when you click Apply. To avoid this problem, use a
computer with a wired connection to access the modem router.
Consider Every Device on Your Network
Before you begin, check the following:
• Every wireless computer has to be able to obtain an IP address by DHCP from the router
as described in
Use Standard TCP/IP Properties for DHCP on page 18.
• Each computer or wireless adapter in your network is required to have the same SSID
and wireless mode (bandwidth/data rate) as the router. Check that the wireless adapter
on each computer can support the mode and security option you want to use.
• The security option on each wireless device in the network is required to match the router.
For example, if you select a security option that requires a passphrase, be sure to use
same passphrase for each wireless computer in the network.
To Next Page
Loading...
Need help?
General
