Security Settings
56
N150 Wireless ADSL2+ Modem Router DGN1000
Set the Time Zone
The wireless modem router uses the Network Time Protocol (NTP) to obtain the current time
and date from one of several network time servers on the Internet. You can check and set (if
needed) the time zone to ensure time stamps match your local time.
To set the time zone:
1. Select Security > Schedule to display the following screen:
Figure 11. Time zone options
2. Select your time zone. This setting determines the blocking schedule and time-stamping of
log entries.
3. If your time zone is in daylight savings time, select the Adjust for Daylight Savings Time
check box to add one hour to standard time.
Note: If your region uses daylight savings time, select Adjust for Daylight
Savings Time on the first day and clear it after the last day.
4. The wireless modem router has a list of NETGEAR NTP servers. If you would prefer to use
a particular NTP server as the primary server, select the Use this NTP Server check box,
and enter its IP address.
5. Click Apply to save your settings.
To Next Page
Loading...
Need help?
General
