EasyManuals Logo

NETGEAR N150 User Manual

NETGEAR N150
107 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
Advanced Settings
76
N150 Wireless ADSL2+ Modem Router DGN1000
Note: If your ISP assigns a private WAN IP address such as 192.168.x.x
or 10.x.x.x, the Dynamic DNS service will not work because private
addresses are not routed on the Internet.
LAN Setup
The LAN Setup screen allows configuration of LAN IP services such as DHCP and Routing
Information Protocol (RIP). The wireless modem router is shipped preconfigured to use
private IP addresses on the LAN side and to act as a DHCP server. The wireless modem
router’s default LAN IP configuration is as follows:
LAN IP address. 192.168.0.1
Subnet mask. 255.255.255.0
These addresses are part of the private address range designated by the Internet
Engineering Task Force (IETF http://www.ietf.org/) for use in private networks, and should be
suitable in most applications. If your network has a requirement to use a different IP
addressing scheme, you can make those changes in the LAN IP Setup screen.
Note: If you change the LAN IP address of the wireless modem router
while connected through the browser, you are disconnected. To
reconnect, open a new connection to the new IP address and log in.
To set up the LAN:
1. Select Advanced > LAN Setup.

Table of Contents

Other manuals for NETGEAR N150

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR N150 and is the answer not in the manual?

NETGEAR N150 Specifications

General IconGeneral
WiFi Technology802.11n
WiFi SpeedUp to 150 Mbps
Frequency Band2.4 GHz
ModelN150
Ethernet Ports4 x 10/100 Mbps
SecurityWPA/WPA2-PSK
AntennaInternal
Weight0.66 lbs

Related product manuals