EasyManuals Logo

NETGEAR N150 User Manual

NETGEAR N150
107 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #86 background imageLoading...
Page #86 background image
Troubleshooting
86
N150 Wireless ADSL2+ Modem Router DGN1000
Router Not On
When you turn the power on, the power, LAN, and DSL LEDs should light as described here.
If they do not, refer to the sections that follow for help.
To check the LEDs:
1. When power is first applied, the Power LED lights.
2. After approximately 10 seconds, the LAN and DSL LEDs light as follows:
a. The LAN port LEDs light for any local ports that are connected.
b. The DSL link LED lights to indicate that there is a link to the connected device.
c. If a LAN port is connected to a 100 Mbps device, verify that the LAN port’s LED is
green. Note that if the LAN port is 10 Mbps, the LED is amber.
Power
LAN Ports (1–4)
DSL
Internet
Wireless
WPS
Figure 16. Front panel LED Icons
Power LED Is Off
If the Power and other LEDs are off when your router is turned on:
Check that the power cord is correctly connected to your router and the power supply
adapter is correctly connected to a functioning power outlet.
Check that you are using the 12-V DC power adapter supplied by NETGEAR for this
product.
If the error persists, you could have a hardware problem and should contact NETGEAR
Technical Support.

Table of Contents

Other manuals for NETGEAR N150

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR N150 and is the answer not in the manual?

NETGEAR N150 Specifications

General IconGeneral
WiFi Technology802.11n
WiFi SpeedUp to 150 Mbps
Frequency Band2.4 GHz
ModelN150
Ethernet Ports4 x 10/100 Mbps
SecurityWPA/WPA2-PSK
AntennaInternal
Weight0.66 lbs

Related product manuals