NETGEAR ProSafe FVG318

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
6-28 Basic Virtual Private Networking
v1.0, October 2005
7. Use the VPN Status screen to activate the VPN tunnel by performing the following steps:
a. Open the FVG318 management interface and click on VPN Status under VPN to get the
VPN Status/Log screen shown below.
b. Click on VPN Status (in Figure 6-30) to get the IPSec Connection Status screen
(Figure 6-31). Click on Connect for the VPN tunnel you want to activate.
c. Look at the VPN Status/Log screen (Figure 6-30) to verify that the tunnel is connected.
Note: The VPN Status screen is only one of three ways to active a VPN tunnel. See
“Activating a VPN Tunnel” on page 6-29 for information on the other ways.
Figure 6-30
Figure 6-31