NETGEAR ProSafe FVG318

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
Basic Virtual Private Networking 6-13
v1.0, October 2005
In this example, type 192.168.3.1 in the Subnet field as the network address of the
FVG318.
e. Enter 255.255.255.0 in the Mask field as the LAN Subnet Mask of the FVG318.
f. Select All in the Protocol menu to allow all traffic through the VPN tunnel.
g. Select the Connect using Secure Gateway Tunnel check box.
h. Select IP Address in the ID Type menu below the check box.
i. Enter the public WAN IP Address of the FVG318 in the field directly below the ID Type
menu. In this example,
22.23.24.25 would be used.
The resulting Connection Settings are shown in Figure 6-10.
3. Configure the Security Policy in the NETGEAR ProSafe VPN Client software.
a. In the Network Security Policy list, expand the new connection by double clicking its
name or clicking on the “+” symbol. My Identity and Security Policy subheadings appear
below the connection name.
b. Click on the Security Policy subheading to show the Security Policy menu.
c. Select the Main Mode in the Select Phase 1 Negotiation Mode check box.
4. Configure the VPN Client Identity.
In this step, you will provide information about the remote VPN client PC. You will need to
provide:
Figure 6-11