Hardware Installation 2-1
Chapter 2
Hardware Installation
This chapter provides instructions on how to install and connect the Model RT328 ISDN Router
to a PC for operation and configuration.
Connecting the Router
Even if your Model RT328 router is to be installed in a predominately Macintosh or UNIX
environment, you can connect it to a PC and configure it using FirstGear, as described in
Chapter
3, “Configuring the Router Using FirstGear.” After your router is configured, you can
then connect it back into your UNIX or Macintosh environment.
Follow the diagram in Figure
2-1 to find out about making router connections. For further
information about making each connection, refer to the sections that follow.
RT328.BK Page 1 Wednesday, August 6, 1997 11:14 AM
To Next Page
Loading...
Need help?
General
