Gear units – Operating and Assembly Instructions
2 B 1000 en-2518
Pos: 4 /A nleit ungen /Getr iebe/ 0. Prol og/Sic herhei ts- u nd Anw endung shin weis e für Getri ebe @ 3\ mod_1375086447713_388.docx @ 84071 @ @ 1
General safety and operating instructions
1. General
Depending on its protection class, the device may have live, bare,
moving or rotating parts or hot surfaces during operation,.
Unauthorised removal of covers, improper use, incorrect installation or
operation causes a risk of serious personal injury or material damage.
All transport, installation, commissioning and maintenance work must be
carried out by qualified specialist personnel (national accident
prevention regulations must be observed).
Within the meaning of this basic safety information, qualified specialist
personnel are persons who are familiar with the installation, assembly,
commissioning and operation of the product and who have the training
and experience to recognise and avoid any hazards and risks.
2. Correct use
NORD products may only be used according to the information in the
catalogue and the associated technical documentation.
Compliance with the operating and installation instructions is a
prerequisite for fault-free operation and for the fulfilment of any
warranty claims. These operating and installation instructions must
be read before working with the device!
These operating and installation instructions contain important
information about servicing. They must therefore be kept close to the
device.
All details regarding technical data and permissible conditions at the
installation site must be complied with.
3. Transport, storage
Information regarding transport, storage and correct handling must be
complied with.
4. Installation
The device must be protected against impermissible loads. In particular,
during transport and handling, components must not be deformed or
changed. Touching of electronic components and contacts must be
avoided.
5. Electrical Connection
When working on live three-phase motors, the applicable
national accident prevention regulations must be complied with
(e.g. BGV A3, formerly VBG 4).
The electrical installation must be implemented according to the
applicable regulations (e.g. cable cross-section, fuses, earth
lead connections).
Information regarding EMC-compliant installation – such as
shielding, earthing and installation of cables – can be found in
the three-phase motor documentation. Compliance with the
limiting values specified in the EMC regulations is the
responsibility of the manufacturer of the system or machine.
6. Operation
Appropriate safety measures must be taken for applications
where failure of the device may result in injury.
Where necessary, systems in which NORD devices are installed
must be equipped with additional monitoring and protective
equipment according to the applicable safety requirements, e.g.
legislation concerning technical equipment, accident prevention
regulations, etc.
All covers and guards must be kept closed during operation.
7. Maintenance and repairs
After the device has been disconnected from the power supply,
live equipment components and power connections should not
be touched immediately, because of possible charged
capacitors.
Further information can be found in this documentation.
These safety instructions must be kept in a safe place!
Pos: 6 /A nleit ungen /Getr iebe/ 0. Prol og/Do kumen tatio n - Versi onsl is te [B 10 00] @ 3 \mod_1375086449142_388.docx @ 84096 @ @ 1
114
To Next Page
Loading...
