Gear units – Operating and Assembly Instructions
10 B 1000 en-2518
Pos: 23 /Anlei tunge n/Ge triebe /1. Hin weis e/Bes timmu ngsg emäße Ver wend ung [_Ti tel] @ 3\mod_1370592165719_388.docx @ 76375 @ 2 @ 1
1.3 Correct use
Pos: 24 /A nl eitu nge n/G etr iebe /1. Hin weis e/B es timm ung sg emäß e Ver wend ung [Te xt_B 1000] @ 3\mod_1368692523034_388.docx @ 65793 @ @ 1
These gear units generate a rotational movement and are intended for use in commercial systems.
The gear unit must only be used according to the information in the technical documentation from
Getriebebau NORD.
Commissioning (start of intended operation) is prohibited until it has been established that the
machine complies with the local laws and directives and all health and safety requirements have been
met. The EMC Directive 2004/108/EC and the Machinery Directive 2006/42/EC in their currently valid
scope of application must be complied with in particular.
DANGER
Explosion hazard
Serious injury and material damage due to explosion are possible.
Use in explosion hazard areas is prohibited.
WARNING
Injury to persons
Appropriate safety measures must be taken for applications where failure of a gear unit or geared motor may
result in injury.
Safeguard a wide area around the hazard zone.
WARNING
Material damage and personal injury
If the gear unit is not used as designed, this may cause damage to the gear unit or the premature failure of
components. Personal injury as a result of this cannot be ruled out.
Strict compliance with the technical data on the type plate is essential. The documentation must be observed.
122
To Next Page
Loading...
