NETZSCH NM125BY B.1 Series - Page 95

List of illustrations
B 1000 en-2518 7
Pos: 13 /Allge mein/ Steu ermodul e/Ab bild ungsv erzei chnis @ 0\mod_1317978515699_388.docx @ 3917 @ @ 1
List of illustrations
=== Ende der Liste f ür T e xtmar ke A b bildu ngs ver zeic hni s == =
Abbildung 1: Typenschild (Beispiel) mit Erläuterung der Typenschildfelder .......................................................... 15
Figure 2: Activating the vent plug .......................................................................................................................... 20
Figure 3: Activating the vent plug .......................................................................................................................... 20
Figure 4: Removing the vent plug and fitting the special pressure vent ................................................................. 20
Abbildung 5: Beispiel einer einfachen Aufziehvorrichtung ..................................................................................... 22
Abbildung 6: Richtige Montage von Abtriebselementen ........................................................................................ 22
Figure 7: Applying lubricant to the shaft and the hub ............................................................................................. 23
Figure 8: Removing the factory-fitted closing cap .................................................................................................. 24
Figure 9: Gear unit mounted to shaft with a shoulder using the fastening element ............................................... 24
Figure 10: Gear unit mounted to shaft without a shoulder using the fastening element ........................................ 24
Figure 11: Dismantling using dismantling device ................................................................................................... 24
Figure 12: Mounting the rubber buffer (Option G or VG) on parallel shaft gear units ............................................ 25
Fig. 13: Attaching the torque support on bevel gear and worm gear units ............................................................. 25
Figure 14: Hollow shaft with shrink disc ................................................................................................................. 26
Figure 15: Fitting the covers, Option SH, Option H, and Option H66 ..................................................................... 28
Fig. 16: Removal and fitting of the cover cap........................................................................................................ 28
Figure 17: Fitting the coupling onto the motor shaft - various types of coupling .................................................... 30
Figure 18: Cooling cover ....................................................................................................................................... 31
Figure 19: Connecting the cooling system ............................................................................................................. 32
Figure 20: Activating the automatic lubricant dispenser with standard motor mounting ........................................ 34
Figure 21: Adhesive label ...................................................................................................................................... 35
Figure 22: Checking the oil level with a dipstick .................................................................................................... 40
Figure 23: Replacing the automatic lubricant dispenser with standard motor mounting ........................................ 40
Figure 24: Oil level check with oil level tank .......................................................................................................... 44
119