BA 3001 En – Edition 2.0 * 345001b210.fm 2-11
Safety instructions
Hydraulics
• Work on the hydraulic equipment of the machine must be carried out only by persons
having specific technical knowledge and experience in hydraulic systems!
• Check all lines, hoses and screwed connections regularly for leaks and obvious
damage! Repair any damage and leaks immediately! Splashed oil can cause injury and
fire.
• In accordance with the Operator's Manual/instructions for the respective assembly,
release the pressure in all system sections and pressure pipes (hydraulic system) to be
opened before carrying out any implementing/repair work!
• Hydraulic and compressed-air lines must be laid and fitted properly. Make sure no
connections are interchanged. The fittings, lengths and quality of the hoses must
comply with the technical requirements
Noise
• During operation all sound baffles must be closed.
• Wear ear protectors if necessary!
Oil, grease and other chemical substances
• When handling oil, grease and other chemical substances (e.g. battery electrolyte –
sulphuric acid), observe the product-related safety regulations (safety data sheet)!
• Be careful when handling hot consumables – risk of burning or scalding!
Battery
• When handling the battery observe the specific safety instructions and regulations
relevant to accident prevention. Batteries contain sulphuric acid – caustic!
• Especially when charging batteries, as well as during normal operation of batteries, an
oxyhydrogen mixture is formed in the battery cells – danger of explosion!
• In case of a frozen battery or of an insufficient electrolyte level, do not try start-up with a
battery jump cable. The battery can burst or explode
☞ Dispose of the battery immediately!
Tyres
• Repair work on the tyres must be carried out by technical staff or by an authorised
workshop only!
• Defective tyres reduce the machine's operational safety. Therefore carry out regular
checks of the tyres for
• Cracks, cuts or other damage
• Check the tyre pressure at regular intervals.