3-28 BA 3001 En – Edition 2.0 * * 345001b330.fm
Operation
3.19 Crane handling the machine
Safety instructions
• The crane and the lifting gear must have suitable dimensions.
• Crane handling the machine requires suitable lifting gear.
• Secure the machine against unintentional movement!
Incorrect crane handling of the machine –
Danger of accidents!
☞ Make sure no-one is near the machine!
☞ Have loads fastened and crane operators instructed by experienced
persons only! The person giving the instructions to the crane operator must
be within sight or sound of him!
☞ Make sure the crane and the lifting gear (cables, chains) have sufficient
lifting capacity!
☞ Raise the machine only if the skip is empty!
☞ Stay clear of suspended loads!
☞ It is essential that you read the safety instructions at the beginning of this
chapter and follow any other safety instructions relevant in your country!
☞ Load the machine as follows:
• Empty the skip
• Lower the skip
• Stop and park the machine
• Lock the control levers
– see chapter 3.18 Locking the control levers on page 3-27
• The rollbar can be lowered to reduce the transport height.
• Put the centre pivot prop in place
• Use suitable lifting gear, chains etc.
☞ Make the lifting gear pass through bracket 1 on the edge of the skip and fasten it on
eye hook 2 on the chassis!
• Slowly raise the machine
Fig. 44: Crane handling
1
2
To Next Page
Loading...