Neuson 3001 - Replacing the Filter

To Next Page

To Previous Page

BA 3001 En – Edition 2.0 * 345001b520.fm 5-13

Maintenance

Replacing the filter

• Replace filter A as follows:

☞ Switch off the engine

☞ Remove the key and carry it with you

☞ Let the engine cool down

☞ Open the engine cover

☞ Remove dirt and dust from the air filter and the area around the air filter

☞ Fold both bow clips D on lower housing section E to the outside

☞ Remove lower housing section E

☞ Unscrew wing nut F

☞ Carefully remove filter B with slightly turning movements

☞ Make sure all dirt (dust) inside the air filter housing has been removed

☞ Clean the parts with a clean lint-free cloth, do not use compressed air

☞ Check the air filter cartridges for damage, only install intact filters

☞ Carefully insert the new filter B in the air filter housing

☞ Position lower housing section E (make sure it is properly seated)

☞ Close both bow clips D

Fig. 31: Removing the lower housing section

Fig. 32: Removing the filter element