Need help?Do you have a question about the NewMar SilverLeaf RV-C Control System and is the answer not in the manual?
General| Brand | NewMar |
|---|---|
| Model | SilverLeaf RV-C Control System |
| Category | Control Panel |
| Language | English |
Describes the main interface with buttons for system control and status.
Displays AC power source, voltage, current, and frequency.
Configures phase detection and load shedding amperage.
Configures load shedding, generator settling, and charger shedding.
Displays inverter/charger status, battery info, and current flow.
Configures inverter/charger status and max charging current.
Configures charger status, max current, and max charge rate.
Configures low voltage shutdown and battery type settings.
Configures low AC volts, absorption, and float settings.
Displays generator status and allows start/stop control.
Provides global control of heating and cooling for all HVAC zones.
Controls Oasis burner, AC heating elements, and displays status.
Controls floor heat zones via sliders or arrows.
Displays system faults and diagnostic codes.
Allows setting the system time and date.
Configures button color, speaker sound, and volume.
Configures transfer switch, inverter model, floor heat mats, and schedule.
Configures ambient temp instance, AC model, and video switch.
Configures OEM, video camera, waste system, and furnace.
Configures safety lock, auto charger, exerciser, and auto temp.
Configures autocharger start volts, max run time, and topoff settings.
Configures exerciser day, start time, and run time.
Configures autofill run after seconds setting.
Configures autofill start level, stop level, and timeout.
Sets 2-zone floor heat settings for day/night periods.
Sets AM on/off times and settings for 4-zone floor heat.
Sets Fresh, Gray, and Black tank sizes for models.
Determines and sets labels for HVAC zones.
Sets temperature sensors for the HVAC zones.
Configures HVAC scheduling, secondary heat, dehumidifier.
Configures block heater, AC, ambient temp, zone settings.
Configures load type, manager settings, and heat pump temp.
Configures secondary heat mode, boost level, and zone settings.
Configures auto charger, auto temp, and exerciser settings.
Configures auto temperature, generator start/stop triggers, and auto-fill.
Configures furnace, target, thermostat, and echo instances.
To Next Page