- Step 4: Install the Bluetooth Drivers
USB-Link™ Installation and Setup Manual 43
IMPORTANT:
ä If you are installing the Linksys adapter and have followed the previous
instruction directing you to plug in the adapter prior to installing the Blue-
tooth drivers (see “Step 3: Install the Bluetooth Adapter”), you do not need
to perform the last two procedures in this chapter. Move on to “Step 5:
Connect the USB-Link™ to a Vehicle” in Chapter 3.
However, if you are installing another adapter (e.g., the Belkin adapter) or
you failed to install the adapter as instructed (pg. 35), then you may need
to proceed with these instructions depending on which version of Windows
you are running (see instructions following).
If you are running Windows 2000 or XP Service Pack 1 on your PC, skip the next
topic and move on to “Configure the Bluetooth Environment” later in this manual
(pg. 52).
If, however, you are running Windows XP Service Pack 2, continue on to “Addi-
tional Steps for Windows XP SP-2” next in this manual.
NOTE:
i To determine your PC’s operating system (and whether you are running
SP-1 or SP-2), right-click My Computer (found on the Windows desktop).
Select Properties
4
General tab.
Most users (i.e., those installing the Linksys adapter), move on to Step 5 in
Chapter 3. This includes users running the Vista operating system.
To Next Page
Loading...
