Nibe F1345 Series - Page 65

L
Load monitor, 27
M
Marking, 4
Master/Slave, 26
Miniature circuit-breaker, 23
Motor cut-out, 23
Resetting, 24
N
NIBE Uplink, 31
O
Optional connections, 26
Outdoor sensor, 25
P
Pipe connections, 16
Brine side, 18
Cold and hot water
Connecting the hot water heater, 20
Dimensions and pipe connections, 17
Docking alternatives, 21
General, 16
Heating medium side, 20
Pipe dimensions, 17
Symbol key, 16
System diagram, 16
Pipe dimensions, 17
Possible selection for AUX inputs, 32
Possible selection for AUX output (potential free variable
relay), 33
Possible selections for AUX output, 33
Post adjustment and bleeding, 37
Pump adjustment, automatic operation, 37
Pump adjustment, manual operation, 37
Pump capacity diagram, brine side, manual opera-
tion, 37
Readjusting, venting, heat medium side, 40
Power connection, 24
Preparations, 35
Pump adjustment, automatic operation, 37
Brine side, 37
Heating medium side, 37
Pump adjustment, manual operation, 37
Heating medium side, 38
Pump capacity diagram, brine side, manual operation, 37
R
Readjusting, venting, heat medium side, 40
Relay output for emergency mode, 30
Reversing valves, 31
Room sensor, 28
S
Safety information, 4
Inspection of the installation, 7
Marking, 4
Safety precautions, 5
Symbols, 4
Safety precautions, 5
Shunt controlled additional heat, 29–30
Start guide, 36
Step controlled additional heat, 29
Supplied components, 9
Symbol key, 16, 36
Symbols, 4
System diagram, 16
T
Technical data, 45
Dimensions and setting-out coordinates, 45
Electrical wiring diagram, 3x400 V 24 kWElectrical
wiring diagram, 3x400 V 28 kW, 53
Technical Data, 46
Technical Data, 46
Working range heat pump, 47
Temperature sensor, external flow line, 26
Temperature sensor, hot water charging, 25
Temperature sensor, hot water top, 26
The heat pump design, 11
Component list cooling section, 14
Component location cooling section, 14
Component locations, 11
List of components, 11
Transport, 8
W
Working range heat pump, 47
65Item registerNIBE F1345