Nice AVIO500 - Advanced Programming; Backjump Adjustment

STEP 11
Thecontrolunit hasadditionalspecialfeatures not requiredfor
mostofstandardinstallations.Alldescriptionsarereportedhere
below.
10.1 – BACKJUMP ADJUSTMENT
Thisprocedureallowsforadjustingoreliminatingthebackjump.
Itconsistsininvertingthedoormovementattheendofthepath
to perform belt recovery,facilitateunlocking and safeguard the
mechanicalsystem. Oncertaininstallationsthisisunnecessary,
thereforethisvaluecanbeadjusted.
DEFAULT:backjump=value2,equalto500ms
Prior to proceeding with this progra mming procedure,
rst verify whether either the “basic path programming” or
the “advanced path programming” have been completed.
Backjumplevels:0/500ms/700ms/1Sec/1,5Sec/2Sec.
When the series consists of one flash, the backjump value is
zero(noinversionofmovementatend-of-path),whenthereare6
ADVANCED PROGRAMMING
ACTION RESULT
01. PUTTHEDOORINTHECLOSEDPOSITION
02. PRESS THE STARTBUTTONFOR3SECOND
AlltheLEDsturnonandthenturnoff(ifnot,consultparagraph
10.3.1)
03. PRESS THE SETBUTTONFOR1SECOND
Theyellow“set”LEDturnsoninthefixedmodeandthered
“error”LEDindicatesthebackjump*level
04. PRESS THE SETBUTTONFOR1SECOND
Theyellow“set”LEDflashesthenturnsoninthefixedmode
andthered“error”LEDindicatesthebackjump*level
backjump value setting
05.
EVERYTIMETHESETBUTTONISPRESSED,
THEVALUECHANGESFROM1TO6STARTING
FROMTHECURRENTLYSETVALUE
1
5
2
4
36
example1:
currentbackjump=3
afterSETispressed,backjump=4
example2:
currentbackjump=5
afterSETispressed2times,backjump=1
Theyellow“set”LEDremainslitinthefixedmodeandthegred
“error”LEDindicatesthebackjump*level
saving of the set backjump
06. PRESS THE RADIOBUTTONFOR2ECONDS
Theyellow“set”LEDremainslitinthexedmodeandthered
“error”LEDashesfast
07.
PRESS THE SETANDRADIOBUTTONS
SIMULTANEOUSLY
TheLEDsreturntothenormaloperationconguration
*Thebackjumpvalueisindicatedbythenumberofflashesoftheseriesbasedonthesetvalue.
flashes,thebackjumpissettothemaximumvalue.
Clearly,theotherseriesindicategrowingintermediatevaluesfrom
1to6.
The backjump value can be known at any time after the SET
buttonispressedthefirsttime,bycountingthenumberofflashes
ofthegreen“photo”LED.
If the backjump value is set too high, some undesired
clearance may remain between the door and the mechani-
cal stop.
22–English
English