VBA10201-R.3577.A
- Ａ8 ･ -
Screw Lock
After adjustment
Lens release
button
1.7 ± 0.1 ｍｍ
#185
#624
Lens release pin
Bayonet surface
3.4 ± 0.1 ｍｍ
Aperture lever
① Set the A/M switch cam #122 to "S".
After pressing the lens release button two
or three times, measure the height of the AF
coupling shaft #185.
② Adjust the height of the AF coupling shaft
using screw #624.
③ The AF coupling shaft should not protrude
over the bayonet surface, when the height of
lens release pin is adjusted to 0.4mm.
④ After adjusting, x screw #624 using the
screw lock.
● Measure the height of the aperture lever using tool
J18004.
Standard Value：3.4±0.1mm
If the height of the aperture lever is out of the
standard, bend the circled position to adjust. While
adjusting, take care not to bend the inside lever and
stopper portion.
HIGHT ADJUSTMENT OF AF COUPLING SHAFT#185
ADJUSTMENT OF APERTURE LEVER POSITION
To Next Page
Loading...
