Nikon D100 VBA10201 - Assembly and Adjustment Procedures; Front Body Assembly and Adjustment; Rear Body Assembly and Adjustment

VBA10201-R.3577.A
- -
ASSEMBLY AND ADJUSTMENT
……………………………………………………………………… A1
…………………………………………………………………… A2
…………………………… A3
……………………………………………………… A4
………………………………………………………………… A4
………………………………………… A5
……………………… A6
………………………………………………… A6
……………………………………………………………………… A7
…………………………………………………………… A7
……………………………………… A8
…………………………………………… A8
……………………………………………………………………… A9
……………………………………………………………………… A9
………………………………………………… A10
………………………………………………… A11
………………………… A11
………………………………………………………… A12
……………………………………………………… A13
………………………………………………… A14
…………………………………………… A15
…………………………………………………… A15
……………………………………………………………………………… A16
………………………………………………………………………… A16
……………………………………………… A17
…………………………………………………………………… A18
…………………………………… A19
1. FRONT BODY
Mirror Holder
Mirror Up Lever
Aperture Control Unit
1. Assembly of Aperture Upper and Lower Base Plates
2.Aperture Lever Installation
3.Hook the spring
4.Adjustment for the aperture Mg position
5.Installation of the Apertuer Control unit on the Front Body
AF Driving Unit, AM Switch Unit
Bayonet Mount
Horizontal AF Lever Unit
Hight Adjustment Of AF Coupling Shaft#185
Adjustment of Aperture Lever Position
TTL SPD Unit
AF Sensor Unit
Prism Box Unit
1.Assemble of Penta Box Section
2.Mount Prism Box on Front Body
Angle Adjustment of Main Mirror and Sub Mirror to 45
°
Adjustment of Innity (∞)
AE SPD Position Adjustment
Main FPC
1. Mount Main FPC to Front Body
2. Pressure Welding and Solder Bridge
3. Connect FPCs to Connectors
SQ FPC
Shutter
1. Mirror up
2. Mount Shutter Unit to Front Body
2. REAR BODY
Bottom Plate Unit
Battery Contact and Small Parts on Rear Body