Nikon D3 VBA18001 - Page 92

- Ａ  ･ -
VBA18001-R.3719.A
logo�Q0440�forGraphic
070518�Gdesign�ito
● Writing of the image sensor unique data
Based on the procedure of the image adjustment software, read the shot QR code on the playbacked
screen with two-dimensional barcode reader and write the image sensor-unique data into the DG-PCB.
Set the settings of the two-dimensional barcode reader. (ref. Page 58)
※ BEFORE assembly, take a picture, with a digital camera, of the QR code that is attached to the FPC of
the image sensor holder unit.
・When the image sensor holder unit is replaced, or the DG-PCB unit and the image sensor holder unit are
replaced, take a picture of the QR code of the image sensor of RP.
・When the DG-PCB unit is replaced, take a picture of the QR code of the image sensor holder unit that is
attached to the body.
【Shooting condition】
Compact digital camera is used:
・Quality: FINE
・Size: 3M
・Shooting mode:BSS
・AF mode: Closeup mode
・SB mode: Flash cancel
【How to conrm】
＊ Perform "QrReader (J65096)". Play back the image of the shot QR code, and conrm that reading of the
QR code on the playback screen can be read out with two-dimensional barcode reader. (Page A58- 60)
INC