332
❚❚ Vibration Reduction (VR)
Vibration reduction (VR) reduces blur caused by camera shake,
allowing shutter speeds up to 4 stops slower than would
otherwise be the case (measured at 140 mm with a D300s
camera according to Camera and Imaging Products Association
[CIPA] standards; effects vary with the photographer and
shooting conditions). This increases the range of shutter speeds
available and permits hand-held, tripod-free photography in a
wide range of situations.
Using the Vibration Reduction ON/OFF Switch
• Select ON to enable vibration reduction. Vibration
reduction is activated when the shutter-release
button is pressed halfway, reducing the effects of
camera shake for improved framing and focus.
• Select OFF to turn vibration reduction off.
To Next Page
Loading...
