Contents
1-2
4. Setting Up the Microscope ................................................................................................................ 1-71
4.1 List of Parts .................................................................................................................................. 1-71
4.2 Setup Procedure .......................................................................................................................... 1-74
4.2.1 Assembling Each Part and Attaching Them to the Microscope....................................... 1-74
4.2.2 Attaching the N-STORM Kit ............................................................................................. 1-85
4.2.3 Attaching the Laser Safety Kit.......................................................................................... 1-87
4.2.4 Attaching the Stage Up Kit ............................................................................................... 1-89
4.2.5 Attaching the Back Port Unit ............................................................................................ 1-92
5. Laser Unit ............................................................................................................................................ 1-93
5.1 Overview of the Laser Units ......................................................................................................... 1-94
5.1.1 AOM Controller (Optional) ............................................................................................. 1-100
5.1.2 LU-LR Four-laser PS Rack ............................................................................................ 1-101
5.2 C-LU2 Two-laser Unit, and C-LU3 Three-laser Unit .................................................................. 1-103
5.2.1 Preparation.....................................................................................................................1-103
5.2.2 Laser Installation............................................................................................................ 1-104
5.2.3 Laser Rough Adjustment................................................................................................ 1-106
5.2.4 Final Adjustment for the Ar Laser Light with the Optical Fiber....................................... 1-113
5.2.5 Final Adjustment for the He-Ne Laser Light and 405 Laser Light
with the Optical Fiber ..................................................................................................... 1-119
5.2.6 Attaching the Sheet Metal Covers ................................................................................. 1-121
5.3 C-LU3EX Three-laser Unit EX ................................................................................................... 1-122
5.3.1 Preparation.....................................................................................................................1-123
5.3.2 Laser Installation............................................................................................................ 1-125
5.3.3 Laser Rough Adjustment 1............................................................................................. 1-128
5.3.4 Laser Rough Adjustment 2............................................................................................. 1-139
5.3.5 Final Adjustment for the Ar Laser Light with the Optical Fiber....................................... 1-146
5.3.6 Final Adjustment for the He-Ne Laser Light and 405 Laser Light
with the Optical Fiber ..................................................................................................... 1-152
5.3.7 Adjusting the AOM Controller (When the AOM Unit Used Only) ................................... 1-154
5.3.8 Attaching the Sheet Metal Cover ................................................................................... 1-155
5.4 LU4A Four-laser Module A ......................................................................................................... 1-156
5.4.1 Preparation.....................................................................................................................1-157
5.4.2 Laser Installation............................................................................................................ 1-161
5.4.3 Laser Rough Adjustment 1............................................................................................. 1-171
5.4.4 Laser Rough Adjustment 2............................................................................................. 1-183
5.4.5 Final Adjustment for the Ar Laser Light with the Optical Fiber....................................... 1-189
5.4.6 Final Adjustment for Other Laser Light with the Optical Fiber ....................................... 1-194
5.4.7 Removing the AOTF Driver Remote Controller ............................................................. 1-196
5.4.8 Attaching the Sheet Metal Cover ................................................................................... 1-197
5.5 Setting Up the LU-LR Four-laser PS Rack ................................................................................ 1-198
5.5.1 System Description........................................................................................................ 1-198
5.5.2 Mounting Laser Power Supply....................................................................................... 1-201
5.5.3 Details on Mounting Laser Supply ................................................................................. 1-207
To Next Page
Loading...
Need help?
General