Page 15/55 68_Afficheur_Multidisplay_um_UK_11
Depending on the information selectable units are “knots”, “meters per second”,
kilometres per hour”, “degrees Celsius” and “degrees Fahrenheit”.
• In parameters go to « Unit Selection » Select the unit and press
• Choose the unit and press to save.
2.5.10 Maintenance
2.5.10.1 Multidisplay node address in the Topline system
In this menu you have to give a Topline address to the Multidisplay. With address
n°1 it will be considered as « Master » and manages the whole system. If there is
already a Master », the Multidisplay will get an address different from 1 and it will
behave as « Slave ». This process is carried out automatically: if there is no
« Master » in the system, the Multidisplay will automatically be selected as
« Master ». Systems with an existing « Master » will automatically deliver a « Slave »
address to the Multidisplay.
Note: the Multidisplay comes with a factory default setting as n°0. It has no address
and it cannot work with your system. Giving an address to the Multidisplay is the
very first setting to do once the display is connected to the Topline bus and the
installation complete.
Multidisplay address process:
• Connect the red wire of the Multidisplay on the braid and start the installation.
• A message appears on the display : « disconnect the red wire to start
initialization » (follow this procedure)
• The Multidisplay starts automatically and takes the first Topline address
available. After this procedure, please isolate the red wire in your nke bus
junction box.
• Resetting the address to 0 :
• With the Pad display, go to >> >> Maintenance >> Topline address.
Select « Erase » and save with .
Address change process :
• With the Pad display, go to >> >> Maintenance >> Topline Address.
Select « Yes » and save with .
• The Multidisplay takes another address and takes the first one available.
To Next Page
Loading...