NKE MULTIDISPLAY - Activation of an Alarm; Race Timer; Using the Race Timer

Page 26/55 68_Afficheur_Multidisplay_um_UK_11
2.7.2 Activation of an alarm
When an alarm is activated a window will appear showing which data is activating the
alarm and an audible signal is emitted. The data for this channel is displayed in red
on the relevant page of the Multidisplay. Press to pause for 10 minutes. If after
10 minutes the conditions are still met for the alarm to activate, the window will
resume.
If you want the rest of your instruments to ring when an alarm triggers on the
Multidisplay, you need to activate the Topline alarm, first line in the alarm menu.
2.8 RACE TIMER
The race timer works as a countdown before the start of a race. Two different race
procedures can be set up as « T1 » and « T2 ». The default settings are 5 minutes
for « T1 » and 4 minutes for « T2 ». At the end of the countdown, a short audible
signal is emitted at the 10 last seconds signal and the start time triggers a long
audible signal. These audible signals are repeated by every display.
Once the countdown reaches « 0 », the timer starts for the race time in hours and
minutes.
The timer data is available on the Topline for any display to repeat it.
2.8.1 Using the race timer
• Setting the race timer with the Pad Display
(See Pad Display manual)
• Starting the race timer with the Pad Pilot or Display
To start the timer, proceed as follow:
• Set up a page with the timer (See display setting 2.3)
• Once on your timer page, press a window will appear to « Start
timer T1 », press .
• A single press on enables to start the timer. If you want to synchronize
Time T2, press again and start the second timer.
To start the race timer with the remote:
To start the race timer with the remote, your timer will have to be on an X1 page.