Page 40/55 68_Afficheur_Multidisplay_um_UK_11
Dead Angle
Allows a dead angle from 0 to 3° on the rudder angle.
2.11.5 Gyropilot operation
This section of the manual describes the use and operation of the Multidisplay once
installed and calibrated. For installation and calibration, refer to the installation
section, page 70.
The default factory settings of the Gyropilot will perform well on most boats.
To power your system on use the general switch panel where two separate 12 V
power supplies are installed for:
• The power drive and the processor (refer to the installation guide of the
Gyropilot2)
• The Topline bus where all sensors and displays are connected.
•
Operation with compass mode
The compass mode requires a compass sensor and a boat speed sensor.
Steer the boat onto a suitable heading, allow time for the boat to settle on this course
with the rudder on mid-ship position and press Auto to engage the Gyropilot.
The pilot will steer to the current heading which is automatically set as course to
steer.
Return to manual steering by pressing stop once when you are ready at the helm.
The following graphic shows the pilot page as it will be displayed on the Multidisplay
when the Gyropilot is engaged in compass mode.
Always turn the power drive and processor on before the Topline bus.
To Next Page
Loading...
