Issue 2 06/2005 COMPANY CONFIDENTIAL 47
Copyright © 2005 Nokia. All Rights Reserved.
RH-53/54
Nokia Customer Care
Autotuning
Autotune feature is designed to align product’s RF part easier and faster. By this autotune com-
ponent the product is tuned automatically. The user only needs to press ‘Tune’ and the prod-
uct’s RF is tuned and results are shown to the user. Component controls all the needed RF
equipment (RF generator and TX measuring device) except voltage supplier.
NOTE! Automatic tuning is ALWAYS the primary tuning mode. Manual tuning is not recom-
mended.
Following diagram describes how the Autotune component is located in the TSS architecture:
Figure 3:
Autotune component in TSS architecture
Autotune is a pair of two different components. One is User Interface and the other is FunctioN-
al. UI does not contain any functionality. MTI takes care of phonet messages.
The Autotune component can be found under Tuning menu:
To Next Page
Loading...
