Issue 2 06/2005 COMPANY CONFIDENTIAL 9
Copyright © 2005 Nokia. All Rights Reserved.
RH-53/54
6-Disassembly and Assembly Instructions Nokia Customer Care
20.) Remove the Cable carefully. When assembling
always starts with the Antenna Connector, "stretch" the
cable towards hinge area carefully, then the same proce-
dure when assembling at Engine Module side.
21.) Unscrew the two Torx Plus
®
size 5 screws from
Lower Block. For assembly, a Torx Plus
®
driver with a
torque of 6Ncm has to be used.
22.) Put the Lower Block on the Upper Block as shown in
the Picture.
23.) Lift the shown side of the Flex Connector carefully
by using the Flex Opening Tool as a lever.
24.) Now, open the Connector carefully. 25.) Separate the Modules.
26.) Open the hooks before removing the Plastic Hinge. 27.) Take care not to damage the Flex Connector when
removing the Plastic Hinge.
To Next Page
Loading...
