Issue 2 06/2005 COMPANY CONFIDENTIAL 63
Copyright © 2005 Nokia. All Rights Reserved.
RH-53/54
Nokia Customer Care
Set the spectrum analyser or GSM tester for the required settings and press “OK” If a GSM
tester is used, set the TX data type to random so that the tester can trig on the signal.
Figure 54:TX tuning
Tune the highlighted values to the wanted power (Use average burst power)
Tune the base level to –25dBm
When done press Save&Continue and Phoenix will automatically shift from lowband to
highband. At the same time the intermidiate values are calculated, but that is first seen
next time you start a tuning.
Figure 55:TX tuning
To Next Page
Loading...
